Using Point and Press Programming

in REVTV SupportTips

This method allows you to program the remote control without the use of codes. Instead, the remote control automatically finds the correct command that you select in a variety of codes until you find the code that operates your device. You then lock in the correct code as described below.

Programming your electronic devices using the [Ch +] or [Ch -] buttons (“Power” function during programming)…

1. Turn on all the electronic devices (TV, VCR, DVD, AUDIO) you want to program the remote to operate.

2. Press [OK], then [MUTE] together until the power/mode buttons illuminate in slow-rotation.

3. Press and hold the [CH +] button until one device turns off. While you are pressing the [CH +] button, the power/mode buttons will illuminate in fast-rotation. As soon as one device turns off, release the [CH +] button.

4. Press [MUTE]. If the device that turned off…

  • Turns back on, press [OK] to lock in this code. The power / mode buttons will blink 3-times and go out

OR

  • Does not turn back on, press [CH -] one step at a time until that device turns back on. Each time you press the [CH -] button, the power/mode buttons will illuminate once in reverse fast-rotation. Once you have found a code that turns the device on/off, press [OK] to lock in this code. The power / mode buttons will blink 3-times and go out.

5. Repeat steps 2 to 4 above for each of the remaining electronic devices you wish to program the remote to operate.